• Message Us
  • Skip to content

    WrapCut - edge cutting tape

    Original price $25.00 - Original price $25.00
    Original price
    $25.00 - $25.00
    Current price $25.00

    WrapCut® Vinyl Cutter
    Don’t risk cutting and damaging your paint!
    Trim wraps, create racing stripes and anything else that is difficult to do with a knife.
    Dimensions: width 1/8” length 200′
    Use for shapes, turns, corners; around bumpers, door handles, mirrors…

    👇 How to use...

    WrapCut® Application Process
    How to cut vinyl with WrapCut edge cutting tape.

    Step One

    WrapCut Step 1
    Apply WrapCut to the surface with the filament (tape edge) positioned on the desired trim line. Leave about 4 inches of tape exposed beyond the edge of the film so that the cutting filament can be located. Press both the film and tape down firmly to the surface.

    Step Two
    WrapCut Step 2
    To create a pull tab, use a cutting tool to make a cut or incision in the tape approximately 1 to 2 inches from the end of the tape. Do not cut through the filament.

    Step Three
    WrapCut Step 3
    Placing a finger on the tape where the cut was made, tug the end piece of tape, freeing the end piece of the tape to create a pull tab.

    Step Four
    WrapCut Step 4
    Using the pull tab, pull the bare filament free from the tape and then in the direction of the vinyl right up to the edge where the cutting will begin.

    Step Five
    WrapCut Step 5
    While pressing the film down at the edge where the filament enters, give the filament a quick tug to begin cutting through the vinyl.

    Step Six
    WrapCut Step 6
    Continue pulling the filament with a steady motion along the edge of the tape and at a 45 degree angle towards the direction of the trim line.

    Step Seven
    WrapCut Step 7
    This picture shows the tape being removed simultaneously with the film. The film can also be removed first, leaving the tape in place for removal afterwards.

    Step Eight
    WrapCut Step 8
    This picture shows an alternative method whereby the film was removed from above the trim line, leaving the tape hidden below the remaining film. WrapCut tape is very strong allowing for easy removal from beneath the film without damaging the film edge.